| FT231X – Full Speed USB to Full Handshake UART |
|
This USB2.0 Full Speed IC offers a compact bridge to full handshake UART interfaces. The device is a UART, capable of operating up to 3MBaud, with low power consumption (8mA). The FT231X includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over a UART interface |
|
- Single chip USB to asynchronous serial data transfer interface.
- Entire USB protocol handled on the chip. No USB specific firmware programming required.
- Fully integrated 2048 byte EEPROM for storing device descriptors and CBUS I/O configuration.
- Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.
- Data transfer rates from 300 baud to 3 Mbaud.
- 512 byte receive buffer and 512 byte transmit buffer utilising buffer smoothing technology to allow for high data throughput.
- FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.
- Configurable CBUS I/O pins.
- Transmit and receive LED drive signals.
- UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity
- Synchronous and asynchronous bit bang interface options with RD# and WR# strobes.
- Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.
- Device supplied pre-programmed with unique USB serial number.
- Supports bus powered, self powered and high-power bus powered USB configurations.
- Integrated +3.3V level converter for USB I/O.
- True 3.3V CMOS drive output and TTL input.
- (operates down to 1V8 with external pull ups and is also 5V tolerant)
- Configurable I/O pin output drive strength.
- Integrated power-on-reset circuit.
- UART signal inversion option.
- Internal 3.3V/1.8V LDO regulators
- Low operating current of 8mA (typical) and USB suspend current of 125uA (typical) current.
- Low USB bandwidth consumption.
- UHCI/OHCI/EHCI host controller compatible.
- USB 2.0 Full Speed compatible.
- Extended operating temperature range: -40°C to 85°C
- Available in compact Pb-free 20 Pin SSOP and QFN packages (both RoHS compliant).
|
|
|
- USB to RS232/RS422/RS485 Converters
- Upgrading Legacy Peripherals to USB
- Cellular and Cordless Phone USB data transfer cables and interfaces
- Interfacing MCU/PLD/FPGA based designs to USB
- USB Audio and Low Bandwidth Video data transfer
- PDA to USB data transfer
- USB Smart Card Readers
- USB Instrumentation
- USB Industrial Control
- USB MP3 Player Interface
- USB FLASH Card Reader and Writers
- Set Top Box PC - USB interface
- USB Digital Camera Interface
- USB Hardware Modems
- USB Wireless Modems
- USB Bar Code Readers
- Dedicated Charger Port (DCP) detection enabling battery charging at higher current for faster charge times.
|
| Inventory from our Authorised Distributors |
|
|
UMFT231XA - FT231XQ Based USB to Full Handshake UART Development Module
UMFT231XB - FT231XQ Based USB to Full Handshake UART Breakout Module
UMFT231XC - FT231XQ Based USB to Full Handshake UART and Battery Detection Development Module
LC231X - FT231XQ based USB to UART module
For more information on these modules click here
|
|
| NerO; Energy Efficient Arduino UNO Compatible Design |
- Ft231x Usb Uart Driver Download Windows 10
The FT231XS is an USB2.0 Full Speed IC, offers a compact bridge to full handshake UART interfaces. The device is an UART, capable of operating up to 3Mbaud, with low power consumption (8mA). The FT231XS includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over a UART interface. Driver Ft232r Usb Uart Windows 7 32 Bit Also, this driver is absolutely free to download and all you have got to do is simply click the free download link given at the end. FT232R USB UART Driver is supported on all the major versions of Microsoft Windows such as Windows XP, 7, 8.1, and Windows 10. This driver is for the CB-FTDI USB to Serial cable (CSI Part# 17394 - Black Cable). Support is for Windows XP/Vista/7/8/10 32 & 64 bit. This driver is not compatible with the SC-USB Interface. Note: Install the driver before plugging the cable into your computer. Download and Install a Cisco USB Console Connection. Advanced Driver Options, FTDI. More work to build a device, FT232R is definitely 5 or 3.3 volts chip, where the FT231X is a 3.3V chip though the gpio input are 5V tolerant.
Ft231x Usb Uart Driver Download Windows 10
USB RS232 - FTDI designs and supplies USB semiconductor devices with Legacy support including royalty-free drivers. Application areas include USB RS232, ( USB Serial ), USB Parallel, USB Docking Stations, and upgrades of Legacy designs to USB.